Setting Up An Ip Address - Kodak HERO 4.2 Extended User Manual

To connect to a network using WPS:
1. Press .
2. Touch , then touch Network Settings.
3. Touch Wi-Fi Set-Up Wizard.
: The Wi-Fi radio turns on automatically when you select Wi-Fi Set-Up Wizard.
4. Touch WPS Connect.
5. Select one of two methods of connecting:
Before you make a selection on the printer, make sure you know where the router's push button is, or
:
where to enter the generated PIN. If necessary, consult your Internet Service Provider or router device
manufacturer's documentation for more information.
Pressing a button
: You will have two minutes to press or
select the WPS button. It may be a button
on the device or a virtual button in the
device's software.
a. Touch Push Button Configuration.
b. Press or select the WPS button for your wireless
router.
c. Touch OK on the control panel.
6. When the confirmation message appears, touch OK.
When the printer is successfully connected, the Wi-Fi connectivity LED stops blinking and remains lit.
The printer with a wireless connection is listed as the name of the printer plus a number (for example,
KodakHERO4.2+XXXX).
7. If you haven't installed the KODAK All-in-One Printer Software:
a. Go to www.kodak.com/go/aiodownloads.
b. In the results list, click the link for KODAK All-in-One Printer Software for your computer's operating system.
c. Follow the on-screen instructions.

Setting up an IP Address

You should only need to set up an IP Address for your printer if you are having a problem connecting your printer
:
to a wireless network. Typically, it is not necessary to set up an IP Address. This procedure is for advanced users
who know how to obtain the IP Address for the printer.
www.kodak.com/go/aiosupport
KODAK HERO 4.2 All-in-One Printer
Entering a PIN
a. Touch Generate WPS PIN.
b. In your wireless router's software, locate the
PIN screen.
c. Enter the PIN you received on the LCD into
the PIN screen, then follow the router's
instructions.
d. Touch OK on the control panel.
9