Midea MLTE45N4BWW Service Manual page 10

Service manual for Dryer Machine Midea America Company
when you want to take some garments out for ironing. The unit will beep 8 times when the
moisture in the clothes is good for ironing. At this time, you can take those garments out and
continue drying the other by pressing the START/PAUSE button once. NOTE: The unit will not
stop operating if you don't take those garments out for ironing.
9. Time Adjust+\-
Press these buttons repeatedly to adjust the drying time for Manual cycles. (These buttons do not
work for Sensor cycles.)
10. SIGNAL
Press and hold Time Adjust- Button for three seconds to turn off the buzzer sound.
Press and hold Time Adjust- Button again to activate the sound.
Your selection will be kept until next pressing.
11. Digital display
This digital will display the time of cycle you are setting or remaining time of cycle operating.
12. Cycle status display
The relative indicator Light will be flash when the dryer is in its drying program, other process
indicators to be executed are lit.
13. ECO DRY
Press to select the ECO DRY mode. The ECO DRY mode is a power saving mode that reduces
power while providing efficient drying performance.
• To save energy, turn ECO DRY on.
• To dry quickly, turn ECO DRY off.
14. Wrinkle Care
Press to turn the Wrinkle Care program on or off. When turned on, the Wrinkle Care indicator lights
up. Wrinkle Care provides approximately 90 minutes of intermittent tumbling in unheated air at the
end of the cycle to reduce wrinkling. The load is already dry and can be removed at any time
during the Wrinkle Care cycle.
15. MY CYCLE
Press and hold for 3 seconds to remember your favorite drying cycle.
Press once to load your favorite cycle setting.
16. Smart Control
Press[ ] 3 seconds ,the machine will be connected to the internet on your smart phone, you can go
to the settings and turn on the wireless connection and select an AP (Access Point).
The details of Wi-Fi connect, please check the part of Smart Control.This is the Wi-Fi switch, if you
want to make your appliance connect to the internet, you need turn on this button.
After connecting your device to WiFi, press [ ] once , indicating that it has entered the remote
control state.
Smart phone smart control should meet the following conditions:
1. The appliance should connect to the internet;
2. The door of drum should be closed.
Remark:
-. If the door is open in anytime, the smart control function will be failure.
-. The smart control function is turned off at the end of each cycle automatically, if you want to use
smart control function again, youneed turn on it again.
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 10 －