Powerpanel Plus Main Window Description; Powerpanel Plus Setup Window - CyberPower CPS1500AVR User Manual

POWERPANEL PLUS MAIN WINDOW DESCRIPTION

1. Input Voltage - This reading shows the
current input voltage of the utility power. The
input normally displays in green, but will
appear in red if the input voltage is lower
than 85v of higher than 150v.
2. Battery Level - This indicator displays
the current charge on the battery. The
indicator will turn red during a power failure.
3. Frequency - This indicator displays the
frequency of the utility power.
4. Scheduled On - PowerPanel Plus can
be scheduled to turn your computer system
on. This indicator displays Scheduled on
settings that will occur in the next seven
days.
5. Final Countdown - When PowerPanel Plus detects that the utility voltage is below 85v or above
150v, the final countdown will begin. When the countdown reaches zero, PowerPanel Plus will save
and close any open files, and then shut down the system in an intelligent and orderly manner.
6. Approximate Backup Time - This indicator shows the approximate amount of backup time that
is available, based upon the battery capacity and the load on the system. This indicator can appear
in red, yellow, or green, depending upon the number of minutes available.
7. Scheduled Off - PowerPanel Plus can be set to automatically shutdown the computer at a user
specified time. Scheduled Off settings that are set to occur within seven days are displayed.
8. Temperature - This indicator displays the internal operating temperature of the unit.
9. Load Level - This indicator shows the % of capacity of the battery outlets that is currently being
used. This indicator appears in green or gray, but will turn red if the load exceeds 90%.
10. Output Voltage - This indicator shows the output voltage of the UPS.

POWERPANEL PLUS SETUP WINDOW

1. Sensitive to variation on Line Voltage -
This feature is for other CyberPower
Products. The 1500AVR has Automatic
Voltage regulation, so this is not needed.
2. Auto-Restart - This feature restores
power to the outlets when AC power returns.
3. Software Broadcast - When enabled,
the software will play audible voice prompts
through your computer speakers.
4. Time Between Power Failure and
Shutdown - This is the user controllable
delay between when the power fails and the software starts the shutdown process. If unchecked, the
UPS will run until the low battery signal is received (2 minutes of backup time remaining) and then
start the shutdown process.
5. Time Between Power Failure and Initial Warning - This setting determines the delay between
when the power fails and the first audible alarm.
TM
TM
TM
TM
Guaranteed Uninterruptible Power System
TM
7
CPS1500AVR
TM