Definitions For Led Indicators - CyberPower CPS1500AVR User Manual

DEFINITIONS FOR LED INDICATORS

Power On Wiring AVR
Fault
On Off Off
On Off Flash
On Off On
Off On/Off Off
Off On/Off Off
On/Off On/Off On/Off/Flash On/Off
Off Off Off
Off Off Off
On/Off On/Off On/Off/Flash On/Off
The load indicator LED will turn red if the load is between 80 and 100%.
If the load or battery charge is under 20%, no indicator LED will illuminate.
Using Circuit Alarm
Battery Breaker
Off Set Off
Off Set Off
Off Set Off
On Set Two Beeps Utility Failure - The UPS is providing battery power to the
On Set Rapid Beeps Utility Failure - The UPS is providing battery power to the
Set Long Beep Overload - Turn the UPS off and unplug at least one piece of
On Up Long Beep Overload - Turn the UPS off and unplug at least one piece of
Off Set Off
Set/Up None
Guaranteed Uninterruptible Power System
Normal
AVR - Max. boost 15% of input voltage for output regulation
while input voltage is from 8% to 30% under nominal.
AVR - Max. buck 15% of input voltage for output regulation
while input voltage is from 8% to 26% over nominal.
battery outlets.
battery outlets. Rapid beeps indicate that the battery will run
out of charge within a few minutes.
equipment. Wait 5 seconds, reset the circuit breakers and
restart the UPS.
equipment. Wait 5 seconds, reset the circuit breakers and
restart the UPS.
Surge Protection Malfunction - Power surge has damaged
the unit. Please contact CyberPower Systems.
Electrical Wiring Fault - Indicates a wiring problem such as a
bad ground, missed ground or reversed wiring within the AC
outlet. User is advised to disconnect all equipment from the
outlet and have it checked by an electrician.
13
CPS1500AVR
Condition