Overhead Rigging - JB Systems POWERBALL COLOR Operation Manual

ENGLISH
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. IR RECEIVER: point your IR Remote to this area if you want to control the
unit
2. DISPLAY: shows all the necessary information about settings and working
modes.
3. INTERNAL MICROPHONE: is used to synchronize the sound controlled
shows to the beat of the music. You can set the sensitivity of this microphone
in the menu or via the last DMX channel when you use the 8 channel or 10
channel mode.
4. MENU BUTTON: used to browse the different menu options
5. UP BUTTON: to go up in the menu and to increase the values shown on the display
6. DOWN BUTTON: to go back in the menu and to lower the values shown on the display
7. ENTER BUTTON: used to confirm your choice
8. MAINS INPUT: Connect the supplied mains cable here
9. MAINS LINK OUTPUT: use a special Combi Cable to connect this output with the mains input of the
next POWERBALL unit for easier linking
10. DMX INPUT: receives instructions from a DMX-controller (in DMX
mode) or from the Master unit (in Master/Slave mode).
11. DMXOUTPUT: used to connect the unit with the next unit in the DMX
chain.
12. M-DMX INPUT: Please note that this USB-connector is NOT used for
updates or to connect the unit to a PC! Instead this USB-connector
makes it very easy to add wireless DMX to the unit! Just add the
(optional) WTR-DMX DONGLE from BRITEQ
wireless DMX! Moreover you will be able to connect other DMX-
controlled equipment to the DMX-output so you can share the wireless
DMX function with all connected units! No extra settings to be made in the setup menu, just follow the
procedure in the user manual supplied with the WTR-DMX DONGLE from BRITEQ
WTR-DMX DONGLE is available from WWW.BRITEQ-LIGHTING.COM (order code: 4645)
13. FUSE:

OVERHEAD RIGGING

A. Holes to fix the omega clamp: Take care to properly fix both locks of the
omega clamp
B. Cable passage: can be used to fix an optional safety cable
• Important: The installation must be carried out by qualified service personal
only. Improper installation can result in serious injuries and/or damage to property. Overhead
rigging requires extensive experience! Working load limits should be respected, certified
installation materials should be used, the installed device should be inspected regularly for safety.
• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
• Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
• The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
• Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
• Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
• The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
JB SYSTEMS®
®
and you will get
3/9
USER MANUAL
®
. The separate
POWERBALL COLOR