Table of Contents
Advertisement
USER PREFERENCES
A C
A C
B
B
Audio setup page
Speaker setup
SPDIF setup
Dual mono/DRC
Channel delay
Sound setup
Surround setup
HDCD
SACD mode
Go to audio setup page
A C
A C
B
B
Speaker setup page
Audio output
STR
LT/RT
Front speak.
SML Stereo
Center speak.
Off
Virt. Surround
Rear speak.
Off
5.1 channel
Subwoofer
Off
Test tone
Off
Dialog
00
Post DRC
Off
Set the audio output
Changing the audio settings
Highlight the menu point you would like to set in the "Audio setup page".
A
Please press "ENTER" or "
select the required audio setting and press "ENTER" to confirm your selection.
You can leave the menu at any time by pressing the button "
control.
Speaker setup
Audio output
Since most DVD discs feature Dolby Digital 5.1 channel soundtracks, you will
need to use the downmix options in case you are not using the 5.1 channel ana-
logue outputs. You have the following setup options:
LT/RT: If you set to LT/RT, a mixed signal of the surround signal will be pro-
duced on the left and right output. The left output signal consists of the front left
signal plus centre and the sum signal of the left and right signal of the surround
speakers. The right output signal consists of the front right signal plus sub-
woofer plus the difference signal of the left and right signal of the surround
speakers. This setting should be used only with Dolby Pro Logic receivers
capable of decoding this signal type.
Stereo: If you plan to use the stereo analogue outputs for a connection to a TV
or receiver, you must enable this setting to downmix the 5.1 channel sound-
tracks of most DVD movies to a stereo format. If you set to stereo, the left sig-
nal consists of the front left signal plus surround left signal and sum signal of
the centre and subwoofer. The right signal consists of the front right signal plus
surround right signal and sum signal of the centre and subwoofer. This setting
should be used for most televisions and stereo audio equipment.
Virt. Surround: This setting simulates the effect of a 5.1 speaker system by
modifying the signal. With help of a phase shifting, the position of the sound in
the room will be changed so that you get the feeling that there are more than
two speakers in the room. This setting should be used with two speaker sys-
tems.
5.1 channel: Select this option if you are using the Dolby Digital/dts 5.1 chan-
nel analogue outputs or if you want to play a DVD-Audio disc via the 5.1 chan-
nel output.
54
" to enter a menu. Use the button "
C
D
" or "
" to
B
" on your remote
Advertisement
Table of Contents
