Omron H3DE Manual page 5

■ Characteristics
Accuracy of operating 1% max. of FS ( 1% 10 ms max. at 1.2-s range) (see note 1)
time
Setting error 10% 50 ms max. of FS (see note 1)
Signal input time 50 ms min. (see note 1)
Influence of voltage 0.5% max. of FS ( 0.5% 10 ms max. at 1.2-s range)
Influence of temperature 2% max. of FS ( 2% 10 ms max. at 1.2-s range)
Insulation resistance 100 M min. at 500 VDC
Dielectric strength Between current-carrying metal parts and exposed non-current-carrying metal parts: 2,000 VAC for 1 min.
Between control output terminals and operating circuit: 2,000 VAC for 1 min.
Between contacts of different polarities: 2,000 VAC for 1 min.
Between contacts not located next to each other: 1,000 VAC for 1 min.
Vibration resistance Malfunction: 0.5-mm single amplitude at 10 to 55 Hz
Destruction: 0.75-mm single amplitude at 10 to 55 Hz
Shock resistance
Malfunction: 100 m/s
Destruction: 1,000 m/s
Contact material AGNi+gold plating (Use the G6RN-1 at 12 VDC.)
Impulse withstand volt- 3 kV (between power terminals)
age 4.5 kV (between current-carrying metal parts and exposed non-current-carrying metal parts)
Noise immunity Square-wave noise generated by noise simulator (pulse width: 100 ns/1 s, 1-ns rise) 1.5 kV
Static immunity Malfunction: 4 kV
Destruction: 8 kV
Life expectancy Mechanical: 10 million operations min. (under no load at 1,800 operations/h)
Electrical:
EMC (EMI)
Emission Enclosure:
Emission AC Mains:
Harmonic Current:
Voltage Fluctuation and Flickering:
(EMS)
Immunity ESD:
Immunity RF-interference from AM Radio Waves: EN61000-4-3: 10 V/m (80 MHz to 1 GHz) (level 3)
Immunity Burst:
Immunity Surge:
Degree of protection IP30 (Terminal block: IP20)
Weight 120 g
Note: 1. With the H3DE-M@, if the voltage exceeds 26.4 VAC/DC, the following hold at signal OFF for C, D, and G modes:
Accuracy of operating time: 1% 50 ms max. at 1.2-s range
Setting error: 10% +100/ 50 ms max.
Signal input time: 100 ms min.
2. For reference: A maximum current of 0.15 A can be switched at 125 VDC (cos =1).
A maximum current of 0.1 A can be switched if L/R is 7 ms.
In both cases, a life of 100,000 operations can be expected.
The minimum applicable load is 10 mA at 5 VDC (failure level: P).
2
2
100,000 operations min. (5 A at 250 VAC, resistive load at 360 operations/h)
(see note 2)
Solid-state Multi-functional Timer
EN61812-1
EN55011 Group 1 class B
EN55011 Group 1 class B
EN61000-3-2
EN61000-3-3
EN61812-1
EN61000-4-2: 6 kV contact discharge (level 3)
8 kV air discharge (level 3)
EN61000-4-4: 2 kV power port and output port (level 3)
1 kV control port with capacitive clamp (level 3)
EN61000-4-5: 2 kV common mode (level 3)
1 kV differential mode (level 3)
H3DE-M/-S
B-55