Precautions For Correct Use; Confirming Package Contents - Omron Xpectia FZ2-30 Instruction Manual

Fz series vision sensor

Hide thumbs

Table Of Contents

Table of Contents

•

Installation Site

Install the product in a place that meets the following conditions:

• Surrounding temperature of 0 to +50 °C

• No rapid changes in temperature (place where dew does not form)

• Relative humidity of between 35 to 85 %

• No presence of corrosive or flammable gases

• Place free of dust, salts and iron particles

• Place free of vibration and shock

• Place out of direct sunlight

• Place where it will not come into contact with water, oils or chemicals

•

Orientation of Product

To improve heat dissipation, install the product in the

following orientation only.

•

Ambient Temperature

• Maintain a minimum clearance of 50 mm above and below the

controller to improve air circulation. A minimum clearance of

10 mm between other devices must also be maintained on the

right and left sides of the product. However, if the adjacent

devices do not generate heat, provide at least 50 mm of

clearance from the top of the Controller. For the clearance at

the bottom and sides, follow the mounting method.

• Do not install the product immediately above significant

heat sources, such as heaters, transformers, or

large-capacity resistors.

• Do not let the ambient temperature exceed 50 °C (122 °F).

• Provide a forced-air fan cooling or air conditioning if the

ambient temperature is near 50 °C (122 °F) so that the

ambient temperature never exceeds 50 °C (122 °F).

•

Noise Resistance

• Do not install the product in a cabinet containing

high-voltage equipment.

• Do not install the product within 200 mm of power cables.

•

Component Installation and Handling

• OMRON Components

Use only the camera and cables designed specifically for the product.

Failure to observe this may result in malfunction or damage of the product.

• Connecting/Disconnecting Camera and Cables

Always turn OFF the Controller's power before connecting or disconnecting a camera

or cable.

• Touching Signal Lines

To prevent damage from static electricity, use a wrist strap or another device for

preventing electrostatic discharges when touching terminals or signal lines in

connectors.

• Handling a USB Memory

To remove a USB memory, make sure that data is not being read or written to it.

The LED on the USB memory flashes while data is being read or written, so make sure that it is lit steadily before removing the

memory.

• Turning OFF the Power

Do not turn OFF the power while a message is being displayed indicating that processing is being performed. Data in memory will

be corrupted, and the product may not operate correctly the next time it is started.

• Using the RESET Signal

Do not use the RESET input immediately after power is turned ON. When using the RESET input to synchronize startup timing,

wait at least 15 second after the Controller's power supply is turned ON before turning ON the RESET signal.

•

Maintenance

Turn OFF the power and take safety precautions before conducting inspections. Electrical shock can result from attempting safety

inspections with the power turned ON.

• Clean the lens with a lens-cleaning cloth or air brush.

• Lightly wipe off dirt with a soft cloth.

• Dirt on the CCD must be removed using an air brush.

• Do not use thinners or benzene.

Confirming Package Contents

• Controller

• Instruction Manual (this manual)

• Booklet ("Please Read First")

• Mounting bracket (for panel)

• Touch pen