S&P EMI-TECH Manual page 19

DE-ICE: This mode is useful for long absences (second homes), preventing the internal temperature of
your home dropping below 0ºC, thus ensuring that the internal water pipes to not ice up. Also for the times
of the day during which you DON'T want the heater to heat.
Temperature range settable between: +5.0ºC and +10.0ºC (factory-set at +7.0ºC).
ECO: This operating mode is for night hours and also for times of day when nobody is at home (work, school
hours... ) and you don't want the interior temperature to drop below a certain temperature.
Temperature range settable between: +5.0ºC and +19.0ºC (factory-set at +15.5ºC).
COMFORT: This operating mode is for times when you are at home and want a comfortable room tempe-
rature.
Temperature range settable between: +10.0ºC and +30.0ºC (factory-set at +19.0ºC).
Setting the Time / Day of the week / Date
Press the CONFIG/PROG key with short presses, until the clock icon starts to fl ash, then press MODE/OK to enter the
time and date confi guration screen.
Setting the weekly programme
Before starting the weekly setting and to achieve increased energy/fi nancial savings with no loss comfort, you need
to know what the time periods are.
VERY IMPORTANT: Before starting the weekly setting, it is necessary to understand the ITCS (Intelligent tempera-
ture control system) function. See the Heater settings section (
• Press the CONFIG/PROG key with short presses, until the P for programme icon appears fl ashing on the screen.
Then press MODE/OK to enter the weekly programme screen.
will appear on the screen so that the working mode can be set from 00:00 h up to 12:00 h
midday, of day 1 (Monday).
Pressing "+" will change the screen to
i.e. from 12:00 h midday, up to 24:00 h midnight, of day 1 (Monday).
By pressing "+" you skip to day 2 (Tuesday)... and so on until you get to day 7 (Sunday). We can go back a day by
pressing the "-" key.
To set the working mode 1 (Monday), from 00:00 h up to 12:00 h midday, go to this screen.
Press MODE/OK to start setting this programme. Day 1 will stop fl ashing on the screen, leaving
only the 0 h cursor fl ashing on the bottom bar.
By pressing +/- set the different values that are fl ashing, and press the
MODE/OK key to confi rm them before going on to the next value.
Once all the information has been entered, press the CONFIG/PROG key to
save the information.
05) to fi nd out how this function works.
, so that the rest of the day can be programmed,
19