Omron CX-ONE - INTRODUCTION GUIDE Introduction Manual page 31

Online Debug on
Reading a
a Machine
Select [PLC] > [Transfer]
> [To PLC]
Click [Transfer All]
Online
Connection
Project
to PLC
Transferring to the Machine
Transferring to the Machine
Transfer programs and Unit setting parameters created by offline project to the PLC.
In this example, data is sent at the same time to various Units using the batch transfer function.
[Data to be sent]
CPU Unit: Ladder program and PLC System setting data, I/O Table data
CPU Bus Units and Special I/O Units:
AD Unit: Range setting of inputs (1~5v / 4~20mA mode)
Program and configuration data
Program and configuration data
are transferred at the same time
are transferred at the same time
to CPU Bus Units and Special
to CPU Bus Units and Special
I/O Units.
I/O Units.
Transferring
Program
to a
Debug
Machine
CX-One
NS Series PT
NS8-TV00B-V1
System Version 6.0 or later
Program transfer starts.
CJ1W-OC211
Connection Cable
CS1W-CN226(2m)
PLC1
CJ Series PLC CJ1M
CJ1W-ID211
4 ~ 20mA
Connection Cable
XW2Z-200T(2m)
Sensor
Click [Yes].
Click [OK].
Next Page
CJ1W-AD081-V1
Unit No.= 21
CJ1W-NCF71
(CJ1W-MCH71)
Unit No.= 2Hex
CJ1W-DRM21
Unit No.= 0Hex
Node Address= 01
CJ1W-SCU41-V1
Unit No.= 3Hex
CJ1W-CLK21-V1
Unit No.= 1Hex
Node Address= 01
Termination Resistance
Setting= ON
Servo Driver
R88D-WN01L-ML2