Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual page 43

PLC Network
PLC
Start-Up
Start-Up
DeviceNet NT Link
Start-Up Start-Up
• To change the Unit number, change the rotary switch of CPU Bus Units and Special I/O Units
and restart power.
• Check if any error occurs in the PLC (CPU Bus Units and Special I/O Units number overlap
error should be solved).
• Create the I/O Table.
• Check if any error occurs in the PLC
(all errors should be solved).
Controller
CompoWay
Link
/F Start-Up
Start-Up
The I/O Table is created and
The I/O Table is created and
Unit configuration is displayed.
Unit configuration is displayed.
Saving Equipment
System Disass'y /
Config. Reass'y
Click [Yes].
System Controller
Config. Link
Verification Diagnosis