Omron CRT1 - 10-2009 Operation Manual page 245

Units with Connectors
Output Section Specifications
Item
Model
I/O capacity
Internal I/O common
Rated output current
Residual voltage
Leakage current
ON delay
OFF delay
Load short-circuit detection
Disconnection detection
Number of circuits per common
Isolation method
Output indicators
Power supply type
Current supplied to output devices
I/O power supply current consump-
tion
Output handling for communications
errors
Component Names and Functions (Same for CRT1-MD16S(-1)/CRT1-MD16SH(-1))
Indicator Section
Communications
Indicators
CRT1-MD16S
8 outputs
NPN
0.5 A/output, 2 A/common
1.2 V max. (0.5 A
DC, between
each output ter-
minal and the G
terminal)
0.1 mA max.
0.5 ms max.
1.5 ms max.
---
---
8 outputs/common
Photocoupler
LED (yellow)
Multi-power supply
100 mA/output
15 mA max. for 24-VDC power supply voltage
Select either hold or clear from CX-Integrator.
Note Please see "Appendix E: I/O Power Supply Current" regarding the I/O power
supply current supplied to the V and G terminals.
Communications
indicators:
Node address switches:
MS and NS
×10 and ×1 (from left)
Communications
connector
Refer to 4-1-3 Communications Indicators.
Specification
CRT1-MD16S-1
PNP NPN
1.2 V max. (0.5 A 1.2 V max. (0.5 A
DC, between DC, between
each output ter- each output ter-
minal and the V minal and the G
terminal) terminal)
Supported.
Operates at 3 mA/point max.
(Does not operate at over 3 mA.)
Input (upper) and output (lower) indicators
0 to 7
Input
Output
I/O connectors (e-CON connectors)
Output I/O power supply connector
Section 5-4
CRT1-MD16SH CRT1-MD16SH-1
PNP
1.2 V max. (0.5 A
DC, between
each output ter-
minal and the V
terminal)
35 mA max. for
24-VDC power
supply voltage
221