Wali M001LP Installation Manual

INSTALLATION MANUAL
M001LP/M001LP-W
Supplied Parts List
Pole C-Clamp C-Clamp Brace
a (x1) b (x1)
M10 Hand Knob EVA Pad A
m (x1) n (x1)
1
Option A : Clamp Installation
1. Connect Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and a c
tighten with Allen Key 3mm o .
i
c
o
Stick the EVA pad B o to
the C-Clamp Brace c
c
f
Swivel Arm VESA Plate
c (x1) d (x1) e (x2)
EVA Pad B Support Plate Grommet Base Plate
o (x1) p (x1) q (x1)
2. Remove the screw, washer and top plate from the M10 Hand Knob m , then connect the M10 Hand
Knob m and C-clamp b with the screw, washer and top plate that were just removed. m
f
Select the preferred height according to your desk thickness. Connect C-clamp b to C-clamp Brace c
using M8x12 Bolt g , and tighten with Allen Key 5mm i . Rotate the Hand Knob m clockwise to fasten g
for stability.
a
c
i
3mm
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
www.walielectric.com
assembly or inappropriate use.
TIPOVER WARNING
！
support@walielectric.com
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
1-844-SATTLER (18447288537)
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M5x14 Bolt M8x12 Bolt
f (x3) g (x2)
Laptop Tray M4x12 Bolt
r (x1) s (x4)
m
b
b
i m
b
m
m
b
M6 Nut Allen Key M4x12 Bolt
h (x2) i (x1) j (x8)
D4 Nut Anti-skid Pad Wrench
v (x1)
t (x4) u (x4)
Option B : Grommet Base Installation
1. Place Pole a onto Grommet Base Plate m . Connect them from the bottom using M5x14 Bolt a
c
and tighten with Allen Key 3mm
i
c
n
Stick the EVA pad A o to n
g
the Grommet Base Plate q
i
M4x30 Bolt M4 Spacer
k (x8) l (x8)
Wire Clip Wire Clip
w (x2) x (x3)
q
.
a
q
q
f
i
f