Wali M001XLLP Installation Manual

INSTALLATION MANUAL
Dual Mount with Laptop Tray
M001XLLP
Supplied Parts List
Lower Pole Upper Pole
C-Clamp
a1 (x1) a2 (x1) b (x1)
M10 Bolt Support Plate M10 Washer
i (x1) j (x1) k (x1)
M4x12 Bolt M4x30 Bolt M4 Spacer
q (x8) r (x8) s (x8)
2
Option A : Clamp Installation
1. Connect Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and a c
tighten with Allen Key 3mm o . o
a
f
o
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
75x75\100x100
C-Clamp Brace Swivel Arms
c (x1) d (x1)
Spring Washer Grommet Base Plate
l (x1) m (x1)
Laptop Tray M4x10 Bolt
t (x1) u (x4)
f 2. Select the preferred height according to your desk thickness. Connect C-Clamp b to C-Clamp
Brace c using M8x12 Bolt g and tighten with Allen Key 5mm o . Rotate the hand knob c
clockwise to fasten for stability.
c
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
(10kg/22lbs)x2
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
Laptop : 17" Max
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Monitor: 32" Max
VESA Plate M5x14 Bolt M8x12 Bolt
e (x2) f (x3) g (x2)
Wire Clip Wire Clip Allen Key
n1 (x2) n2 (x3) o (x1)
M4 Nut Anti-skid Pad
v (x4) w (x4)
g o
c
b
Hand Knob
1
31.5'' Pole Installation
Loosen the screw on the Lower Pole
Lower Pole
2mm o to fix the two poles. o
Pre-Assembly
Nut
h (x2)
a1
Wrench
p (x1)
Option B : Grommet Base Installation
1. Place Pole a onto Grommet Base Plate m . Connect them from the bottom using a
b
M5x14 Bolt and tighten with Allen Key 3mm
f
g
o
o
with Allen key 2mm o . Connect o
a1 a1
a1 to Upper Pole a2 and tighten the screw with Allen key
a1 a2
a2
a2
o
o
a1
a1
m
o .
a
m
f