Care And Maintenance; Tips And Tricks - Parkside KH 3115 BELT SANDER Manual

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
Material / type of work
Smoothing varnish
Removing rust
Plastic
Non-ferrous metals
(e.g. aluminium)

CARE AND MAINTENANCE

ATTENTION: Before you carry out any work on the belt sander always pull the plug out of the
mains socket.
1) Clean the belt sander regularly. The best time is immediately after you have finished working with it.
2) Do not use any sharp objects to clean the belt sander. Do not allow any liquids to enter the belt
sander. Use a moist cloth to clean the housing - never use petrol, solvents or cleaners that attack
plastic.
3) Always keep the ventilation slots clear.
4) Remove any adhered sanding dust using a narrow paint brush. Unscrew the protective cover
from time to time and carefully clean out the dust channels to ensure optimum dust extraction.
DISPOSAL
The packaging is wholly composed of environmentally-friendly materials that can be disposed of at
a local recycling centre.
Please contact your local council office to find out about disposal facilities for your worn-out
electrical tools.

TIPS AND TRICKS

• Never use the same sanding belt to sand wood and metal.
• Worn or ripped sanding belts can damage the workpiece. Make sure you change the sanding belt at
the appropriate time.
• Keep the sanding belt properly tensioned so that it does not hang down too much and become
unusable due to knicks, creases etc.
You can find further practical tips in the accompanying booklet "Safety Advice".
We reserve the right to make technical modifications in the course of further development.
Coarse sanding (grit) Fine sanding (grit)
150
040
120
080
t
14 14
Speed
320 low (1-2)
120 medium/high (3-4)
240 low/medium (2-3)
150 medium/high (3-4)