Proper Use; Technical Information - Parkside KH 3115 BELT SANDER Manual

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
For sanding large areas. For wood, plastic and metal
Please read carefully through the following information concerning safety and proper use. Before
reading, fold out the page with the illustrations and make yourself familiar with all the functions of
the equipment. Please read the operating instructions
advice carefully. Use the equipment only as described and for the indicated purposes. By doing
this you will be able to work in complete safety and produce better results. Be careful to keep these
advice notes and if necessary pass them on to a third party.

PROPER USE

The belt sander is intended for dry-sanding and polishing wood, metal and paint. Always use a
sanding belt and grade of grit suitable for the particular surface you are sanding. The speed selected
should also be appropriate for the material. Any other use or modification to the belt sander shall be
considered as improper use and could give rise to considerable dangers. The manufacturer will not
accept liability for loss or damage arising from improper use.
FEATURES OF THE PEBS 900
Auxiliary handle
Ventilation slots
Belt speed selector wheel
Locking knob
ON / OFF switch

TECHNICAL INFORMATION

Rated consumption:
Nominal voltage:
Belt no load speed:
Belt /sanding speed
at maximum speed:
Abrasive surface:
Belt:
The PEBS 900 belt sander has full-wave electronics with additional control electronics, overload
control, soft start and power control.
Soft start with inrush current limiting.
PEBS 900 BELT SANDER
900 W
230 V ~ 50 Hz
n 650 rpm
0
350 m/min
75 x 150 mm
75 x 533 mm
t
10 10
below and the accompanying safety
Protective cover
Dust extraction spout
Belt adjuster screw
Tensioning lever
Dust collection bag
Protection class:
Weight:
Sound pressure level:
Sound output level:
Vibration:
II/
3.8 kg
Lp = 87 dB (A)
Lw = 100 dB (pw)
< 2.5 m/s 2 (Hand-
arm vibration)