The belt sander is only to be used for dry sanding. If the mains cable becomes damaged or cut through whilst you are working, never touch the cable - pull the plug out of the mains socket immediately.
Always make sure that the machine is switched off before you pull the socket out of the mains socket. Switch on the belt sander first before you bring it into contact with the workpiece and lift the sander off the workpiece before you switch it off.
Page 6
MATERIAL REMOVED AND SURFACE FINISH The amount of material removed by sanding and the quality of the surface finish achieved depend on the belt speed and the grit size of the sanding belt (see section on “Belt speed and sanding sheet”). The following basic rules apply: the higher the rpm/belt speed you use, the more material is removed and the finer is the sanded surface.
1) Clean the belt sander regularly. The best time is immediately after you have finished working with it. 2) Do not use any sharp objects to clean the belt sander. Do not allow any liquids to enter the belt sander. Use a moist cloth to clean the housing - never use petrol, solvents or cleaners that attack plastic.
WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase (if available) to the closest service address.