Our products are subject to a process of continuous development. Thus, they are subject to change. Please refer to the latest version of the user manual which is ready for download under www.thomann.de. Symbols and signal words In this section you will find an overview of the meaning of symbols and signal words that are used in this manual.
Page 6
General information Warning signs Type of danger Warning – danger zone. LST-250 Lighting Stand...
Safety instructions Safety instructions Intended use This light stand is intended to be used for the stable mounting and height-adjustable posi‐ tioning of spotlights. Use the device only as described in this user manual. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage.
Page 8
Safety instructions CAUTION! Danger of tipping on unsuitable surfaces When the speaker stand is installed on soft or uneven ground, the stand may tip over and cause injuries and property damage. Install the stand only on even and solid surfaces. CAUTION! Danger of tipping due to overload In case of overload, the stand may tip over and cause injuries and property damage.
Features Features Special characteristics: Metal construction with cross-beam for up to four spotlights Extension tubes secured by safety bolt and cotter pin Cross-beam mounting Cross-beam: 1.20 m Maximum weight-bearing capacity: 18 kg Minimum height: 1.25 m Maximum height: 2.60 m Maximum vertical lift: 1.35 m Weight: 6 kg LST-250...
Operating Operating Unpack and check carefully there is no transportation damage before using the product. Keep the equipment packaging. To fully protect the product against vibration, dust and moisture during transportation or storage use the original packaging or your own packaging material suitable for transport or storage, respectively.
Page 11
Operating CAUTION! Danger of tipping due to overload In case of overload, the stand may tip over and cause injuries and property damage. Never exceed the maximum load capacity specified for the stand. CAUTION! Danger of tipping from excessive or one-sided loading In case of excessive or one-sided loading of the truss beam the tripod might tip over, causing injury and property damage.
Page 12
Operating Comply with regulations When installing and operating, make sure to follow the standards and regulations that apply in your country. Assembly Unfold the feet of the tripod until the cross braces are in a horizontal position. Fix this position with the safety screw on the slider to which the three feet are attached. Loosen the safety screw on the crossbar mounting at the upper end of the stand, attach the crossbar and tighten it with the safety screw on the mounting.
Page 13
Operating Attach up to four spotlights to the crossbar. Observe the instructions of the respective manufacturers. The maximum load capacity of 18 kg in total must not be exceeded. Dismounting Remove the spotlight(s). Loosen the Allen screws on the upper and lower tube clamp using the supplied Allen key.
Technical specifications Technical specifications Height, max. 2.6 m Total width 0.95 m Adjustable tripod height 1,25 m … 2,6 m Æ 1.36 m Footprint per tripod Single truss length 1.20 m Tripod tube diameter Æ 20 mm Truss tube diameter Æ...
Page 15
Technical specifications Further information Stand type Lighting stand Incl. crossbar Crank LST-250 Lighting Stand...
Protecting the environment Protecting the environment Disposal of the packaging mate‐ rial For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling.
Need help?
Do you have a question about the Millenium LST-250 and is the answer not in the manual?
Questions and answers