Keypad Function - Honeywell HAC10 Series Manual

(11) Keypad function

Built-in
Symbol single-line
keypad
A
B Status indicator
Menu button
C
Set/Shift
D
button
Up and down
buttons
E
Run button
F
Stop/Reset
button
G
MasterVert Specifications, HAC_V00
Built-in dual-line
keypad
Unit indicator
Menu button
Run button
Stop/Reset button
Left shift and right
shift buttons
Function
Hz: Frequency A: Current V: Voltage A/V: Current or
Voltage
RPM: Revolutions Per Minute %: Percentage
On: Forward running status
Blinking: Reverse running status
Off: Stop status
Press to enter the function menu interface in standby or
running status; press this button to exit the modification
in parameter modification state; press and hold (for 1
second) this button to directly enter the status interface in
standby or running status.
Set function: After changing the value, press this button to
confirm the change.
Shift function: Press and hold (for 1 second) this button to
move the operating position; press and hold to perform
cyclic shift.
Press Up button to increase the operation value, and the
Down button to decrease the operation value.
When the run/stop function is controlled by the keypad,
press this button and the VFD will run forward. The status
indicator is always on for forward running, and blinking for
reverse running.
When the given command channel is controlled by
keypad, press this button to stop the VFD; you can define
whether other command channels are valid through the
parameter [F11.03]; press this button in the fault state to
reset the VFD.
Digital potentiometer: Turn clockwise to increase the
operating value; turn counterclockwise to decrease the
operating value.
OK button: Press this button after modifying the value to
confirm the modification.
Move the operating position leftward and rightward.