Magtek SDK MagneFlex Powder Programmer's Manual page 11

2 - How to Set Up the MagneFlex Powder V2 API
11) Locate the serial number on the label on the bottom of the device. Note the final four digits.
12) Read through the list of pairable devices and locate the device called
where nnnn is the last four digits of the device's serial number (if the device does not show
Go-nnnn
in the list, power it off then power it back on). Below the device name you should see the text
.
Ready to pair
13) Select the device and press the
14) Enter default passcode
then press the Next
After a short period of time, you will see the text
After a few seconds the device will disconnect, which is normal power-saving behavior.
15) The device consumes very little power when not transmitting card data, so it is not necessary to
power off the device to conserve power. If the device appears as
list of Bluetooth devices, swiping a card should cause the device to reconnect briefly, transmit the
card data, then disconnect.
SDK - MagneFlex Powder, Middleware| PIN PEDs | Programmer's Manual ( MagneFlex Powder V2 API )
Page 11
Figure 2-2 – Windows 8 Manage Bluetooth Devices App
button.
Pair
(or the device's actual password if it has been configured differently),
000000
button. Windows will return you to the
DynaProMini-nnnn
Manage Bluetooth devices
below the device you are pairing with.
Connected
Not connected
or
DF II
page.
in the Windows