Table of Contents
Advertisement
10.7
Automatic maintenance
Automatic maintenance enables you to make the router restart regularly, improving the stability
and service life of the router. This function is enabled by default.
To access the page,
Maintenance.
Parameter description
Parameter
System Reboot Schedule
Reboot At
Delay
log in to the web UI of the
Description
Used to enable or disable the automatic reboot function.
Specifies the time when the router reboots automatically every day.
Used to enable or disable the delay function.
−
Ticked: The function is enabled. When the time for rebooting
approaches, if there is any user connected to the router and the
traffic over the router's WAN port exceeds 3 KB/s within 30 minutes,
the router will delay rebooting. If there is any user connected to the
router and the traffic over the WAN port does not exceed 3 KB/s
within 30 minutes, or there is no user connected to the router and the
traffic over the router's WAN port is slower than 3 KB/s within 3
minutes, the router will reboot automatically.
−
Unticked: The function is disabled. The router enters the sleeping
mode during the sleeping time.
When the system reboot schedule function is enabled, the router detects the
traffic over the WAN port continuously within 2 hours after the specified reboot
time and reboot when the traffic requirement for rebooting is met.
router, and navigate to System Settings > Automatic
106
Document Version: V1.1
Advertisement
Table of Contents
