SETTING THE DRIVE JUMPERS
NOTE: Before installing your WD Enterprise drive, you
should review the SCSI concepts presented in this
section. The information will help you configure
each WD Enterprise drive to operate properly in
your system.
The drive is designed for use in a variety of systems.
Therefore, several configuration options can be set using
the option block on the front of the drive (end opposite
the SCSI connector). In most cases you will not need to
change the default settings for normal drive operation.
However, some installations may require you to install or
remove certain jumpers in order to meet system
specifications. Refer to Figure 3.
Figure 3. Option Block
Released 10/18/96