Table of Contents
Advertisement
If Your Drive has a 50-pin or 68-pin Connector
1) Using a non-magnetic screwdriver and four mounting
screws, mount the 50-pin or 68-pin drive in the
computer system's mounting frame as shown in Figure
14. Use four 6-32 mounting screws. Do not install the
screws past .150-inch.
NOTE: When mounting the drive, make sure the SCSI
connector and power connector face the rear of the
chassis.
NOTE: If you plan to install the WD Enterprise drive in
a 5.25-inch bay, you must install the mounting
hardware. Contact your local dealer to obtain a
mounting adapter kit. Rails are sometimes
necessary to complete the installation. Consult
your computer system manufacturer.
&
Released 10/18/96
Advertisement
Table of Contents
