Write Mode; Writing A Tone Memory - Roland SUPER JUPITER MKS-80 Owner's Manual

E. WRITE MODE
An edited program can be written into memory
for storage and later retrieval.
Before going to the following writing procedure,
make sure that the MKS-80 is set to either Play or
Edit mode, if not, turn it to the Play mode.
a. Writing a Tone Memory
0 Set the Memory Area Switch ® to the appro¬
priate position depending on which memory
you wish to use for writing the edited program.
d) Press the Write/Execute Button O , and the
button starts flashing,
(3) if the Tone Button (D is not lighted, press it.
Then it will light up and the Display will respond
as shown right.
(I) If you wish to write into the internal memory
of the MKS-80, set its Protect Switch ® to the
OFF position. And to write into the cartridge,
set its Protect Switch to OFF.
(I) Assign the Tone Number where you wish to
write the edited program by using the Bank
Button © and Number Button .
. •
□□
represents the Tone Number just written.
Now, writing is done, and the Display responds as
shown right.
(D Set the Protect Switch to the ON position.
* Please always keep the Protect Switch ® to the
ON position except for during Writing mode,
In this way, the data in memory will be pro¬
tected from accidental loss.
30