Use and maintenance ENGLISH INDEX MACHINE AND MANUFACTURER IDENTIFICATION FACSIMILE COPY OF EU DECLARATION OF CONFORMITY MACHINE DESCRIPTION HANDLING AND TRANSPORT GENERAL WARNINGS SAFETY INSTRUCTIONS FIRST AID RULES GENERAL SAFETY RULES TECHNICAL DATA PERFORMANCE ELECTRICAL DATA OPERATING CONDITIONS 10.1 ENVIRONMENTAL CONDITIONS 10.2 ELECTRICAL POWER SUPPLY 10.3...
- Machinery Regulations - Electromagnetic compatibility The technical file is at the disposal of the competent authority following motivated request at PIUSI S.p.A. or following request sent to the e-mail address: doc_tec@piusi.com. THE ORIGINAL DECLARATION OF CONFORMITY IS PROVIDED SEPARATELY WITH THE PRODUCT...
VISCOMAT DC translated from italian This manual belongs to Piusi S.p.A., which is the sole proprietor of all rights indi- cated by applicable laws, including, by way of example, laws on copyrights. All the rights deriving from such laws are reserved to Piusi S.p.A.: the reproduction,...
Use and maintenance Burn Hazard To avoid severe burns do not touch hot fluid or equipment. Equipment surfaces and fluid that is heated can become very hot during operation Toxic Fluid Read MSDS’s to know the specific hazards of the fluids you are using. or Fumes Store hazardous fluid in approved containers, and dispose of it according to ap- Hazard...
(50 cSt), causing a degradation in performance with obvious reductions in flow rate as the back pressure increases. 7/124 7 /20 This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Use and maintenance 10.2 ELECTRICAL POWER SUPPLY NOTE Depending on the model, the pump must be fed by three-phase or single-phase alternating current whose nominal values are those indicated in the Table of paragraph TECHNICAL DATA. The maximum acceptable variations from the electrical parameters are: Voltage: +/- 5% of the nominal value ATTENTION...
To maximise performance and prevent damage that could affect pump operation, al- ways demand original accessories. 9/124 9 /20 This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Use and maintenance 11.2 CONSIDERATIONS REGARDING DELIVERY AND SUCTION LINES DELIVERY FOREWORD The choice of pump model to use should be made keeping in mind the viscosity of the oil to be pumped and the characteristics of the system attached to the delivery of the pump. EFFECTS ON The combination of the oil viscosity and the characteristics of the system could, in fact,create FLOW RATE...
IP55. The electrical box of Viscomat 120/1 and 60/2 comes with a terminal board for connection ofthe power cord (optional). In case of connection of the cable kit with pincers (Piusi optional),proceed as follows: •open the terminal box cover;...
Page 12
CABLE (+) CABLE (+) In the event of power connection with cable which is not supplied by Piusi, it is necessary toobserve the following characteristics: • for Viscomat DC 12V - use a bipolar cable with minimum section of 6 mm 2 •...
To avoid affecting the proper functioning of the pump, use a hose-end fitting with a thread of length less than 15 mm. 13/124 13 /20 This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Use and maintenance INITIAL START-UP AVANT-PROPOS VISCOMAT DC series pumps are self-priming and, therefore, able to draw oil from the tank even when the suction hose is empty on start-up. The priming height (dis- tance between the surface of the oil and the inlet opening) must not exceed 2,5 meters.
In normal operating conditions, noise emissions of all models do not exceed 70 dB at a distance of 1 meter from the electric pump. 15/124 15 /20 This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Page 16
Use and maintenance PROBLEMS ET SOLUTIONS For any problems contact the authorised dealer nearest to you. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Lack of electric power Check the electrical connections and the safety systems Rotor jammed Check for possible damage or obstruction THE MOTOR IS of the rotating components NOT TURNING...
Other components, such as pipes, rubber gaskets, plastic parts and wires, must be dis- parts disposal posed of by companies specialising in the disposal of industrial waste. 17/124 17 /20 This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
VISCOMAT DC translated from italian DIMENSIONS VISCOMAT 60/1 VISCOMAT 60/2 - VISCOMAT 120/1 19/124 19 /20 This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Page 24
¡Descarga el manual en tu idioma! Lataa käsikirja omalla kielelläsi! Téléchargez le manuel dans votre langue! Download de handleiding in uw taal! Pobierz instrukcję w swoim języku! Baixe o manual em seu idioma! Загрузите руководство на вашем языке https://www.piusi.com/ support/search-manuals Bulletin M0128e EN_ 01.2024...
Need help?
Do you have a question about the VISCOMAT 120/1 and is the answer not in the manual?
Questions and answers