Failures - Smeg WM72141BK Instructions For Use Manual

Failures

The washing machine automatically monitors the execution of particular functions during the
operation, and reports any detected failures. In such cases both signal LED's start fl ashing in
certain sequence, accompanied by the audible signal, sounding in the same sequence as the
indicator LED's fl ash. The fl ashing sequence changes in accordance with the nature of the
detected failure.
In some cases you may attempt removing certain failures yourself, so count the number of fl ashes,
repeating after certain pauses.
The machine signals failures immediately after detecting them and stops the program, except for
heater failure, where the machine completes the washing program without heating water.
Failures
In certain cases you may remove the failure yourself:
2 - two fl ashes: door is not correctly closed
3 - three fl ashes: inappropriate water intake
7 - seven fl ashes: inappropriate water outlet.
In all other instances mark the number of fl ashes indicating the failure, switch off the machine and
call nearest authorized service center (LED's continue fl ashing until you switch the machine off).
Interferences from the ambient (for example electrical wiring) could induce signalization of different
faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the environment (lightning
stroke, power supply circuit faults, natural disasters).
20
• Insert the fi lter back as shown on the picture (arrow and
pointer), and tighten by turning it in clockwise direction. To
ensure good sealing the gasket surface (A) must be dirt free.