Failures - Smeg LB86 Instructions For Use Manual

Failures

24
The washing machine automatically monitors
the execution of particular functions during the
operation, and reports any detected failures. In such
cases both signal LED's start flashing in certain
sequence, accompanied by the audible signal,
sounding in the same sequence as the indicator
LED's flash. The flashing sequence changes in
accordance with the nature of the detected failure.
In some cases you may attempt removing certain
failures yourself, so count the number of flashes,
repeating after certain pauses.
The machine signals failures immediately after
detecting them and stops the program, except for
heater failure, where the machine completes the
washing program without heating water.
Failures
In certain cases you may remove the failure
yourself:
2 - two flashes: door is not correctly closed
3 - three flashes: inappropriate water intake
7 - seven flashes: inappropriate water outlet.
In all other instances mark the number of flashes
indicating the failure, switch off the machine and call
nearest authorized service center (LED's continue
flashing until you switch the machine off).
Interferences from the ambient (for example
electrical wiring) could induce signalization of
different faults. In such cases:
- switch the appliance off, and wait for a few
seconds;
- switch the appliance back on and repeat the
washing program.
If the fault repeats, call authorized service shop.