Failures - Smeg Washing Machine WM62121 Instructions For Use Manual

Failures

The washing machine automatically monitors the execution of particular
functions during the operation, and reports any detected failures. In such
cases signal LED's start flashing in certain sequence, accompanied by the
audible signal, sounding in the same sequence as the indicator LED's flash.
The flashing sequence changes in accordance with the nature of the detected
failure.
In some cases you may attempt removing certain failures yourself, so count the
number of flashes, repeating after certain pauses.
The machine signals failures immediately after detecting them and stops the
program, except for heater failure, where the machine completes the washing
program without heating water.
Failures
In certain cases you may remove the failure yourself:
2 - two flashes: door is not correctly closed
3 - three flashes: inappropriate water intake
7 - seven flashes: inappropriate water outlet.
In all other instances mark the number of flashes indicating the failure, switch
off the machine and call nearest authorized service center (LED's continue
flashing until you switch the machine off).
Interferences from the ambient (for example electrical wiring) could induce
signalization of different faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the
environment (lightning stroke, power supply circuit faults, natural disasters).
4