Smeg WM72141BK Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Smeg Manuals
  4. Washer
  5. WM72141BK
  6. Instructions for use manual

Smeg WM72141BK Instructions For Use Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Instructions for Use
Washing machine

Advertisement

Table of Contents
loading

Related Manuals for Smeg WM72141BK

Summary of Contents for Smeg WM72141BK

  • Page 1 Instructions for Use Washing machine...

  • Page 2: Table Of Contents

    legislation.

  • Page 3: Description Of Washing Machine

    4. Filter lid 8. Mains power cable Technical information Dimensions (w x d x h): 600 mm x 600 mm x 850 mm (depending on model) Dimensions (w x d x h): 600 mm x 440 mm x 850 mm...

  • Page 4: Cautions

    • When connecting your washing machine to water supply, be sure to use brand new water inlet hose and appropriate sealing gaskets (attached). • Do not locate the machine in a room with temperature below 0°C. Parts of the machine may be damaged if frozen.

  • Page 5: Installation And Connection

    • Loosen screws A at the rear of the machine (Fig. 1). • Remove the brackets B (Fig. 1) and slide them into the groove on the blocking rod (Fig. 2) - the right one should be turned around.

  • Page 6: Water Inlet Connection

    Screw the hose thread to the water faucet • In case of hot and cold water connection, connect one hose to cold and other to hot water faucet as marked at the rear of the appliance (letters C and H) (C - cold; H - hot)
  • Page 7 Water outlet connection Water outlet connection • Fix the outlet hose to run into the sink or the bathtub, or connect it directly to the wall drain outlet (diameter min. 4 cm). • Wall drain must be installed properly and must enable occasional cleaning.
  • Page 8 A suitable plug of 13 amp or 15 amp rating should then be fi tted to the cable. The wires in the mains lead are coloured in accordance with the following code (see fi...

  • Page 9: Operation

    Operation A - program selector Signal LED’s: B - lower spin RPM or spin off - washing program stages knob (depending on the model) • wash C - short or half program knob (depending • rinse on the model) • spin...

  • Page 10: Operation Operation

    • Start the operation by pushing the START knob (F). - Open the door of the machine. Door is opened by pulling the handle (lever) on the right hand side of the door towards you. - Sort the laundry by the type of fabrics.
  • Page 11 For heavily stained permanent press use the heavy duty program, or program with the pre-wash If you wish the laundry not to be excessively creased at the end of washing, use easy ironing program For smaller loads (non-delicate cotton, linen, synthetic, and mixed fabric) and smaller quantities of soiled laundry (laundry refreshment, laundry wet with perspiration, etc.), we recommend...
  • Page 12 START button (F). Pump stop • This function is switched on after the selection of a basic program by pressing the knob (E). It may also be switched on during the operation, prior last rinse. Indicator LED above the washing cycle symbol is lit.
  • Page 13 “0” for at least one second). Rinse Independent program for rinsing delicate laundry, without intermediate spinning and with short fi nal spin. You may use it for rinsing manually washed delicate laundry. You may engage the reduced spin RPM knob.
  • Page 14 • As each washing stage is completed the relevant washing stage indicator LED goes off and the subsequent one goes on. • In case you would like to alter the washing program after the initiated washing operation, turn the program selector for one second to the position “0”, followed by the selection of a new...
  • Page 15 PAUSE knob By pressing the PAUSE knob (F) program may be suspended at any time. After certain time you may open the door if there is no water in the drum, otherwise this is not possible. Program is continued by pressing the START knob (F).

  • Page 16: Tips For Washing And Energy Saving

    • Add powder or liquid detergents according to the manufacturer’s instructions. • If water hardness level exceeds 14°dH degrees, the use of water conditioner is required. Any damage to the heater due to failure to use a water conditioning agent shall not be covered by this warranty.
  • Page 17 (depending on model). If you use powder detergent the gate is lifted up, and in case of liquid detergent it is slid down. • Liquid detergents are intended for main wash only, without pre-wash.

  • Page 18: Cleaning And Maintenance

    • The casing should be cleaned with soft cloth and mild detergent. • The interior of the drum and the door gasket is cleaned by washing at 60°C without laundry and adding half quantity of detergent. • If necessary, clean the detergent dispenser. Pull it out from its casing completely by pressing the fl...
  • Page 19 • After each wash wipe the door rubber gasket. This will prolong its useful life. • Open the fi lter lid using fl at screwdriver or similar tool. • Filter needs occasional cleaning, especially following heavily shaggy or old laundry. Before cleaning, drain any water from the machine via drain pipe.

  • Page 20: Failures

    7 - seven fl ashes: inappropriate water outlet. In all other instances mark the number of fl ashes indicating the failure, switch off the machine and call nearest authorized service center (LED’s continue fl ashing until you switch the machine off).
  • Page 21 Disturbed water inlet. Check if: the machine (after • the water faucet is open, approx. 8 min the • inlet pipe net fi lter is clean. machine reports failure Push the START button. -3 fl ashes). Water is leaking from Filter is not tightly screwed in.
  • Page 22 • Washing time is extended by the power supply. power supply down-time. * UKS: universal stability control - this function prevents excessive vibrations during spinning. In case you were not successful in repairing the malfunctions in spite of the above suggestion chart, call the nearest authorized service shop.

  • Page 23: Tables

    Delicate 0,48 Delicate 0,39 Wool 0,20 Manual wash 0,25 1000 0,35 Partial programs Rinse 0,02 Softening 1000 0,02 Pumping water Spinning 1400 0,03 * Testing program by EN 60456 with the selection of max. spin RPM. ** Depending on model.
  • Page 24 0,20 0,20 Manual wash 1,5 30 0,25 0,25 1000 0,32 0,32 Partial programs Rinse 0,02 Softening 1000 0,02 Pumping water Spinning 1400 0,03 * Testing program by EN 60456 with the selection of max. spin RPM. ** Depending on model.
  • Page 25 Synthetics 0,34 Delicate 0,20 Delicate 0,15 Wool 0,15 Manual wash 0,20 1000 0,25 Partial programs Rinse 0,02 Softening max. 1000 0,02 Pumping water Spinning max. 1400 0,03 * Testing program by EN 60456 with the selection of max. spin RPM.
  • Page 26 Program chart/Additional functions Program Basic programs Cotton Cotton with prewash Cotton heavy Cotton - easy ironing Cotton - Quick 17’ Synthetics with pre-wash Synthetics Delicate Wool Manual wash Partial programs Rinse Softening Pumping water Spinning possibility...
  • Page 27 R11, R113, alcohol and in Kerosene R 113 High temperature Drying Place on Hang wet Hang Tumble drying fl at surface not allowed temperature We reserve the rights to make any changes or mistakes in these operation instructions.
  • Page 28 PS PG2 OEM 225199/en (06-08)

Table of Contents