Smeg WM72141BK Instructions For Use Manual page 14

Start the operation Start the operation
14
- Adding washing and softening agents
(see Tips for washing and energy saving)
• pre-wash compartment
• main wash compartment
• softener compartment
If you do not apply the program which includes the pre-wash
feature, you may add washing detergent directly into the drum,
using the measuring vessel.
When adding softener, be careful to fi ll the dispenser
only up to the marked level.
Be sure to close the detergent dispenser when opening/
closing the appliance door.
• Push the START button (F). Sound signal confi rms the start,
the LED indicating particular washing stages stops fl ashing.
The machine starts operating after a few seconds. If the door
is not properly closed after starting the operation, the washing
stage indicator LED starts fl ashing again after a few seconds.
When you close the door, the machine initiates the selected
program.
• As each washing stage is completed the relevant washing
stage indicator LED goes off and the subsequent one goes on.
• In case you would like to alter the washing program after the
initiated washing operation, turn the program selector for one
second to the position "0", followed by the selection of a new
program. Switching the machine off deletes any previously
selected additional functions(i.e. Pump stop), so they have to
be reactivated.
Upon switching OFF, all additional pre-selected
functions are deleted; therefore they must be switched-
ON again.
- End of operation
Flashing LED's for particular washing stages indicate that the
program was completed.
• Sound signal indicates that you may now open the door of the
machine.
• Extract the laundry from the drum and remove any alien
objects from the door gasket.
• Leave the door ajar to allow the interior to dry.
• Close the water inlet faucet.
• Switch the machine off by turning the program selector to
position "0".
Pull the power lead from the socket and cut the power supply
from the mains.