Operation Operation - Smeg WM72141BK Instructions For Use Manual

Washing procedure Washing procedure
Washing machine Washing machine
operation operation
10
• Open the door of the machine.
• Load the laundry into the drum.
• Close the door.
• Open the water inlet faucet.
• Push the ON/OFF button and select the program.
• Add washing and treatment agents (detergent and softener).
• Start the operation by pushing the START knob (F).
- Open the door of the machine.
Door is opened by pulling the handle (lever) on the right hand
side of the door towards you.
- Sort the laundry by the type of fabrics.
Do the buttons and zippers, tie the strings and pull out
the pockets.
Very delicate laundry should be put in a special
protective sack.
It is suggested to load the drum with items of different
sizes.
Pay attention to the labels on the clothes, indicating
the recommending washing mode (see table of
textile treatment symbols on the last page of these
instructions).
- Load the laundry into the drum.
Check that the drum is empty.
- Close the door of the appliance.
- Open the water inlet faucet.
- Push the ON/OFF button and select washing program.
Program is selected by turning the program selector (A) from the
"0" position to the desired washing program. The ON/OFF signal
LED indicating particular washing stage for the chosen program
starts fl ashing. The program selector (A) may be turned in both
directions, and the appropriate program selected according to the
type of laundry washed and the required washing temperature
(see Program Chart for help). You may select basic or partial
programs.
Select additional functions by pressing their relevant knobs (F).
- Selection of basic programs (
Basic programs represent integral programs containing all
washing stages, including softening and spinning (see Program
Chart). They are selected by turning the program selector (A) to
the appropriate position.
, , , , , )