Table of Contents
Advertisement
3.2 Fitting the foam gasket
Before installing the induction hob into a kitchen worktop, attach the foam gasket supplied with the
appliance to the bottom side of the hob. Some appliances come with the gasket already fitted!
1. Remove the protective film from the gasket.
2. Attach it to the bottom side of the glass surface, 2 3 mm away from the edge, along the entire
perimeter of the glass panel.
3. The gasket may not overlap in the corners.
4. When fitting the gasket, make sure it is not damaged by or in contact with any sharp objects.
WARNING!
Do not install the appliance without the gasket!
4. Connecting the induction hob to the power
mains
•
Power mains protection must conform to the relevant regulations.
•
Before connecting the appliance, make sure the voltage specified on the rating plate conforms to
the voltage of the power mains.
•
There should be a switching device in the electrical installation that can disconnect all poles of
the appliance from the power mains, with a minimum clearance of 3 mm between the contacts
when open. Suitable devices include fuses, protective switches etc.
•
The connection should be adjusted to the current and fuses.
•
After installation, the parts carrying electrical current and insulated parts shall be protected against
contact.
WARNING!
The appliance may only be connected by an authorised expert. False connection can destroy
parts of the appliance. In such case, there is no right to warranty! Disconnect the appliance from
the power mains before any repair or maintenance operation.
4.1 Power cord
(appliance without a power cord)
* Ferrules are not supplied.
13
Advertisement
Table of Contents
