Table of Contents
Advertisement
10. EXTRAORDINARY MAINTENANCE
The oven requires periodic minor maintenance or replacement of parts subject to wear, such as gaskets,
light bulbs, etc. Specific instructions for each operation of this kind are given below.
Before any intervention that requires access to live parts, disconnect the appliance from the
power supply.
CAUTION: For your safety, you are advised to wear protective gloves while performing any
cleaning or extraordinary maintenance.
10.1 Removing the door
Open the door completely.
Insert a pin into the hole in the
hinge. Repeat for both hinges.
10.2 Replacing the light bulb (main oven)
If a light bulb needs to be replaced because it is worn
or burnt out, remove the guide frames; see "9.6.1
Removing guide frames".
Then remove the bulb cover using a tool (e.g. a
screwdriver).
Remove the bulb by sliding it out as shown. Replace
the bulb with one of the same type (40W).
Do not touch halogen bulbs directly with your fingers, wrap them in insulating material.
30
Instructions for the user
Grasp the door on both sides
with both hands, lift it forming an
angle of around 30° and remove it.
To reassemble the door, put the
hinges in the relevant slots in the
oven, making sure that grooved
sections C are resting completely
at the base of the slots. Lower
the door and once it is in place
remove the pins from the holes in
the hinges.
Hide quick links:
Advertisement
Table of Contents
