Attaching The Door; Making Connection In Unit - Bosch NBA-7070-PA0 Instruction Manual

Surveillance cabinet
3.5

Attaching the door

The bottom hinge pin of the door has a Hinge Pin Stop to hold the hinge open when you
attach the arm to the unit.
1.
2.
Notice!
i
Both Hinge Pins must be fully pushed to unlock the hinges of the door and before you
proceed to the next step.
3.
4.
Warning!
Serious injury or death can occur if the hinge pins of the door are not fully connected to the
!
unit. Exercise caution before releasing the door.
3.6

Making connection in unit

Make the connections in the unit, depending on your camera model.
1.
2.
Bosch Security System
Push the bottom hinge pin down and rotate it behind the Hinge Pin Stop.
Push the top hinge pin up and hold it.
Hold the top hinge pin open and align the top and bottom hinges of the door to their
mating points on the unit. See the illustration above.
When you have aligned the hinges, release the top hinge pin to connect with its mating
hinge on the unit. Then release the bottom hinge pin from the Hinge Pin Stop to lock
the door to the unit.
Connect the ground wire to the grounding screw on the left side of the unit.
Connect all wires from the door to their mating wires in the unit. (For Fiber Optic
models: connect the 6-pin Control to Dome Plug to the P106 connector.)
Installation manual
Installing the Surveillance cabinet | en
2024-02 | V01 | DOC
17