Tektronix 11A34 Service Reference Manual page 11

2 - a
Checks and Adjustment procedure within the ambient temperature
ON/STANDBY Switch to SWNDBY before installing ofremoving
Turning ths mefnframe power off during probe calibration,
activity may result In some Internal cfeta being corrupted. If
q
Step 1: Power on the followlng test equipment, so that it is warmed up with
the makrfrarne and amplifier to be tested..
Power supply
Calibration generator
Leveled sine wave generators
Digital multimeter
Step 2:
mainframe to a suitable power source.
q
Step 3: Install a Signal standardizer in the Center plug-in compartmsrrt
me Lwt
me 11AM Amplifier in
q
Step 4: Set the front panel ON/STANDBY switch to ON.
q
Step 5:
operation.
connect
the
STANDBY.
and
Checks
and Adjustments