Security Options Configuration - GE 3500/20 Operation And Maintenance Manual

3500/20 Rack Interface Module Operation and Maintenance Manual

3.1.3 Security Options Configuration

This Section describes the options available on the Rack Interface Module Security
Option Configuration screen.
Change Setpoints in Program Mode Only
This will only allow changes to setpoints in any of the monitors only if the keylock
is in the program mode position. If the key is in the run position, setpoint changes
will not be allowed.
Disable Front Communication Port of RIM
This option disables all write functions through the front communication port on
the Rack Interface Module when selected. When in this mode the Rear
Communication Port is still active.
Drive Rack NOT OK Relay if Rack Address is Changed to Run Mode
When selected, this option will force the NOT OK Relay into a NOT OK state if the
Rack Address is changed at any time while the key switch is in the run position.
Drive Rack NOT OK Relay if a Module is Removed From the Rack
When selected, this option will force the NOT OK Relay into a NOT OK state if any
module is removed from its slot in the Rack.
Drive Rack NOT OK Relay if Key Switch is Changed From Run to Program Mode
When selected, this option will force the Rack NOT OK Relay into a NOT OK
stateany time that the key switch is changed from Run to Program mode.
14