Laundering Control; Heating Control - Hisense WFMC6010 Service Manual

3. FEATURES & TECHNICAL EXPLANATION
off, the door is unlocked.
♦The program enters in "Pause mode" from "Run mode", and the unlocking
operation can be executed if conditions permit.
♦ In case of power outage during washing, the door will be unlocked 3 min later
(the specific time depends on the different ambient temperature).
♦The door lock clicks when it executes the program of "lock/unlock".
♦ Door unlocking conditions: the motor stops, the water temperature is below
50°C, and the water level is below the "Door-opening water level".

3.6 LAUNDERING CONTROL

♦After selecting proper program and function the PCB enters in the "Ready
mode", press down "Start/Pause" button, and the PCB controls the door lock to
lock, controls the inlet valve for water inflowing up to the "washing water level",
and then begins the laundering process.
♦The PCB controls the motor to execute intermittent operations in clockwise and
counterclockwise directions at a constant frequency, driving the drum to rotate
via belt sheave for purpose of laundering.
♦Motor speed and rotation/stop ratio under "Cotton" program:
Course Water inflow Pre-wash Wash Rinse
Motor speed 45rpm 45rpm 55rpm 55rpm
Rotation/Stop ratio 10:5 10:5 10:5 12:8

3.7 HEATING CONTROL

♦When the temperature set by the user is higher than the water temperature,
the PCB will control the heater to function and run the heating process until the
water temperature reaches the set temperature.
♦When the temperature set by the user is lower than the water temperature, no
8