Spinning Control - Hisense WFMC6010 Service Manual

3. FEATURES & TECHNICAL EXPLANATION
heating operation is required.
♦The heater is enabled and proceeds to function until 3 seconds pass by after
the set temperature is reached.
♦When the water level is below the "Heating water level", the heater should be
forced to shut down, and then replenish water.

3.8 SPINNING CONTROL

♦During draining, the Spinning process will begin after the water of tub is
discharged down to the "Spinning water level".
♦ The PCB controls the motor to drive the drum to rotate in anticlockwise
direction. Carry out distribution measurement at low speed (about 93rpm) first,
and then measure the equilibrium value. After the equilibrium value is up to
standard, the distribution measurement succeeds, and enter the stage of high-
speed Spinning. If the distribution measurement fails as the equilibrium value is
too big and does not meet the requirements, then it is necessary to continuously
carry out distribution measurement operation.
♦ Spin speed limit: The spin speed shall neither exceed the maximum speed set
by the program nor exceed the speed manually set via the "Spin" button.
♦ During the distribution measurement, time is not reckoned in the first 10 times,
and if the distribution measurement still fails, then the time will decrease
progressively and occupy the Spinning time until the latter is run out.
♦ During Spinning, if the clothes are not spinning at last as the distribution
measurement fails all the time, then "Unb" will flash after the program ends, the
display window is on all the time, and the alarm will give out buzzing sound.
9