Self-Inspection Mode - Hisense WFMC6010 Service Manual

8.TEST MODE

8.1 SELF-INSPECTION MODE

Turn the knob to "Spin" through "Off" to start up the machine and select the "Spin"
program, press the "Temp. + Prewash" button and then press the "Spin" button
once within 5 seconds, the machine will enter into the "Self-inspection mode" 1s
later.
8.1.1 The program enters in C0. All of the icons are off, and meanwhile the door
locking operation is executed. If the door is successfully locked, the "Door lock"
icon is on, and if the door is not locked within 10s, an alarm code of F13 will
display;
8.1.2 If the door is successfully locked, the program enters in C8, and it is time
for the effectiveness detection of buttons and the knob. Press the "Temp" button
to light up all the icons in picture of . Press the "Spin" button to light up all
the icons in picture of . Press the "Prewash" button to light up all the icons in
picture of . Turn the knob one full turn. After all of the operations are
completed, the display state will maintain for 1s, and the program will enter in
C1. If operations of the said steps are not completed, an alarm code of F25 will
display;
8.1.3 The program enters in C1. Turn on the Pre_valve to supply water for 2
seconds, then turn on the Main_valve to supply water for 2 seconds. Keep on
adding water to the heating water level frequency, then the program will enter in
C2.
8.1.4 The program enters in C2. Turn on the Main_valve and Pre_valve together
24