Laundering Control - Hisense WFU7012 Service Manual

3. FEATURES & TECHNICAL EXPLANATION
are satisfied, otherwise, the door should be maintained locked.
♦ After selecting the program and function, press the "Start/Pause" button, the
PCB controls the door lock to execute locking operation, and the "Door lock"
icon on display window is on.
♦ After the program ends, the "Door lock" icon on display window is flickering
when the unlocking conditions are satisfied, and the PCB controls the door lock
to execute unlocking operation. When the "Door lock" icon on display window is
off, the door is unlocked.
♦ The program enters in "Pause mode" from "Run mode", and the unlocking
operation can be executed if conditions permit.
♦ In case of power outage during washing, the door will be unlocked 3 min later
(the specific time depends on the different ambient temperature).
♦ The door lock clicks when it executes the program of "lock/unlock".
♦ Door unlocking conditions: the motor stops, the water temperature is below
50°C, and the water level is below the "Door-opening water level".

3.6 LAUNDERING CONTROL

♦ After the PCB enters in the "Ready mode", select proper program and function,
press down "Start/Pause" button, and the PCB controls the door lock to lock,
controls the inlet valve for water inflowing up to the "washing water level", and
then begins the laundering process.
♦ The PCB controls the motor to execute intermittent operations in clockwise
and counterclockwise directions at a constant frequency, driving the drum to
rotate via belt sheave for purpose of laundering.
♦ Motor speed and rotation/stop ratio under "Cotton" program:
6