Table of Contents
Advertisement
ALWAYS WEAR EYE PROTECTION.
Any power tool can throw foreign
objects into your eyes which could
cause permanent eye damage.
ALWAYS wear safety goggles (not
glasses) that comply with ANSI
safety standard Z87.1. Everyday glasses have only
impact resistant lenses. They ARE NOT safety
glasses.
Glasses or goggles not in compliance with ANSI Z87.1
could cause serious injury when they break.
Never bend the flexible shaft with a radius of less than
6" when operating. Please store the flexible shaft in
the designated compartment of the tool box when not
in use.
NOTES: The head of the flexible shaft should not be
excessively bent. If excessive heating is observed, stop
using the flexible shaft immediately. Remove the cable
from the flexible shaft body and inspect it for a permanent
bend or other damage. Replace damaged cable.
INSTALLATION INSTRUCTIONS
1. Turn Spin Saw motor switch OFF and remove plug
from the power source.
2. Lock main shaft (3) by rotating the collet nut (1) while
pressing on the spindle lock button (4) until the spindle
lock prevents shaft from rotating (see Fig. 29).
3. Remove the collet nut by turning it counter-clockwise.
Remove the collet (2) from inside main shaft of Spin
Saw.
Advertisement
Table of Contents
