8. Wrap threads of nipple adapter (13) with PTFE
PTFE
PTFE
(
) tape.
F
. 17
IG
9. Install nipple adapter (13) to manifold (14) through
hole in front of oil panel (F
13
F
. 18
IG
10. Install swivel elbow (6) and high flow nozzle (15) to
nipple adapter (13). Tighten securely.
13
6
15
F
. 19
IG
6
13
ti12225a
. 18).
IG
ti12232a
ti12233a
Battery Replacement
•
If you cannot remove the battery cover from the
meter following this battery replacement proce-
dure, you will have to completely remove the
meter from the oil bar to replace the batteries.
•
When replacing batteries, always replace all
batteries in the meter using four new batteries.
Do not mix old, used batteries with new batter-
ies.
1. Use an angled screwdriver (as shown in F
a thin coin to turn cover screw clockwise approxi-
mately 1/4 turn. This will loosen the screw that is
securing battery compartment cover sufficiently to
remove cover. (You do not need to completely
remove screw; just loosen it enough to release
cover.)
F
. 20
IG
. 20) or
IG
ti12236a
313013A