Graco 15H874 Instructions Manual
  1. Manuals
  2. Brands
  3. Graco Manuals
  4. Industrial Equipment
  5. 15H874
  6. Instructions manual
Graco 15H874 Instructions Manual

Graco 15H874 Instructions Manual

Slider cylinder rebuild kit
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Instructions
15H874 Slider
Cylinder Rebuild Kit
To rebuild one slider cylinder assembly on E-Flo
Pumps.
Important Safety Instructions
Read all warnings and instructions in this manual
and in E-Flo Plus Repair-Parts manual 311594.
Save these instructions.
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001
311599 rev.A
™
Plus Electric Circulation
ti8317a

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 15H874 and is the answer not in the manual?

Questions and answers

Related Manuals for Graco 15H874

Summary of Contents for Graco 15H874

  • Page 1 Important Safety Instructions Read all warnings and instructions in this manual and in E-Flo Plus Repair-Parts manual 311594. Save these instructions. ti8317a Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001...

  • Page 2: Pressure Relief Procedure

    (13). Kit Parts 5. Shut off electrical power and allow the unit to cool. Slider Cylinder Rebuild Kit 15H874 includes parts Hold slider piston (9) flats with 3/4 in. wrench, and brace to rebuild one slider cylinder assembly. Order two against tie rod (3).
  • Page 3 Kit Installation 6. Disconnect the fluid inlet and outlet lines from the 9. Remove the coupling nut (14) and collars (13) from pump. Plug the ends to prevent fluid contamination. the piston rods (PR). 7. See F . 2. At the pump outlet manifold (17), loosen 10.
  • Page 4 Kit Installation Reassembly 1. See F . 3. Install the two new bearings (8*) on the 8. Install a new black o-ring (41*) on the transducer slider piston (9). The joints between the bearings (25a). must align with the pin hole (PH) in the slider piston. 9.
  • Page 5 Kit Installation Torque to 50-60 ft-lb (68-80 N•m). Torque to 75-80 ft-lb (102-108 N•m). Torque to 15-20 ft-lb (21-27 N•m). Apply lithium grease. ti8723a . 3: Slider Cylinder Rebuild Kit 311599A...

  • Page 6: Graco Standard Warranty

    With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.

Table of Contents