Smeg LB86 Instructions For Use Manual page 25

Failure
The machine does not
work (indicator LED's
are not illuminated).
Washing program
does not start
(washing stage LED is
flashing).
Water does not enter
the machine (after
approx. 8 min the
machine reports
failure -3 flashes).
Water is leaking from
the machine.
The machine moves
during operation.
The machine vibrates
during the spin.
Excessive foaming
during washing.
Water is poorly
pumped out or not at
all (machine reports
failure - seven flashes
of LED).
Laundry is not
properly spun.
No failure is reported.
Possible cause
Machine is not powered.
Door is not properly closed.
Disturbed water inlet.
Filter is not tightly screwed in.
Inlet pipe is not tightly screwed
to the machine or to the water
faucet.
Outlet pipe fell to the floor.
The machine is not properly
leveled.
Transport brackets are not
removed.
Unevenly distributed laundry,
especially with very small
quantities (for ex. only the
bathrobe).
Excessive measure of detergent.
Water outlet is clogged.
The machine switched on the
UKS* function. Because of bad
laundry balance, the machine
has automatically reduced spin
RPM.
Remedy
Check if:
• power in the socket,
• the fuse is OK,
• plug is in the socket.
Push it towards the machine.
Check if:
• the water faucet is open,
• inlet pipe net filter is clean.
Push the START button.
Tighten the filter properly.
Tighten the inlet pipe.
Affix the outlet pipe to the drain.
Level the machine with the adjustable
legs.
Remove transport brackets.
This is normal, the machine will
reduce the RPM if vibrations are too
strong.
Wash larger quantity of laundry.
Use washing powder according to
the instructions by the producer and
according to the water hardness and
soiled laundry.
Use only detergents for machine
washing.
Check if:
• the filter is clean,
• outlet pipe is not jammed,
• outlet pipe is positioned higher than
1 m.
Push START again.
The machine operates normally.
Wash large and small pieces of
laundry together.
25