Smeg LB86 Instructions For Use Manual page 16

Start the operation
16
When adding softener, be careful to fill the
dispenser only up to the marked level.
Be sure to close the detergent dispenser
when opening/closing the appliance door.
•
Push the START button (F). Sound signal
confirms the start, the LED indicating particular
washing stages stops flashing. The machine
starts operating after a few seconds. If the door
is not properly closed after starting the operation,
the washing stage indicator LED starts flashing
again after a few seconds. When you close the
door, the machine initiates the selected program.
•
As each washing stage is completed the relevant
washing stage indicator LED goes off and the
subsequent one goes on.
•
In case you would like to alter the washing
program after the initiated washing operation,
turn the program selector for one second to the
position "0", followed by the selection of a new
program. Switching the machine off deletes any
previously selected additional functions(i.e. Pump
stop), so they have to be reactivated.
Upon switching OFF, all additional pre-
selected functions are deleted; therefore
they must be switched-ON again.
If a power failure occurs during the
washing program, when the power is
restored the machine will resume the
execution of a program where it had been
interrupted.
- End of operation
Flashing LED's for particular washing stages
indicate that the program was completed.
•
Sound signal indicates that you may now open
the door of the machine.
•
Extract the laundry from the drum and remove