20
|
Electrical installation
20.1.3 Guidelines when knocking out knockout holes
20.1.4 Guidelines when connecting the electrical wiring
Installer and user reference guide
104
NOTICE
Precautions when making knockout holes:
▪
Avoid damaging the casing.
▪
After making the knockout holes, we recommend you remove the burrs and paint
the edges and areas around the edges using repair paint to prevent rusting.
▪
When passing electrical wiring through the knockout holes, wrap the wiring with
protective tape to prevent damage.
a
b
a
Knockout hole
b
Burr
c
Sealant etc.
Keep the following in mind:
▪
If stranded conductor wires are used, install a round crimp-style terminal on the
end of the wire. Place the round crimp-style terminal on the wire up to the
covered part and fasten the terminal with the appropriate tool.
b
a
a
Stranded conductor wire
b
Round crimp-style terminal
▪
Use the following methods for installing wires:
Wire type
Single-core wire
c
Installation method
c b
A
A´
c
a
a Curled single-core wire
b Screw
c Flat washer
AA´
a
RXYSA4~6A7V/Y1B
VRV 5-S system air conditioner
4P600330-1A – 2020.07