Operation; Turning The Scale On/Off; Weighing Mode; Enter The Mode And Start Weighing - OHAUS Dafender 3000 i-DT33P Instruction Manual

Defender 3000 Indicators

3. OPERATION

3.1

Turning the Scale On/Off

To turn the scale on, short press the On/Zero Off button. The scale performs a display test, momentarily
displays the software version, the GEO value and then enters the last active weighing mode.
Note: If the hardware lock switch is enabled,
To turn the scale off, press and hold the On/Zero Off button until
3.2

Weighing Mode

Use this application to determine the weight of items in the selected unit of measure. This mode is the default
factory setting.
3.2.1

Enter the Mode and Start Weighing

To enter the weighing mode:
1. Press and hold the Mode button until
2. If needed, place an empty container on the pan and press the Tare button to tare.
Note: To check the tare weight:
a) Long press the Tare button until
b) Release the Tare button and the tare weight will be displayed.
3. Add item to the pan or the container. The display shows the weight of the item.
3.2.2

Application Settings

The application can be customized for user preferences. To enter application settings:
1. Long press the Menu button until you see
C.A.L
.
2. Short press the No button several times until you see
application mode settings.
3. Short press the No button several times to navigate until you see the selection you want.
4. Press the Yes button to select.
5. Repeat step 3 and 4 several times until you finish all settings.
6. Press the Exit button to exit.
The Weighing configurations are defined below (defaults in Bold).
Item
wWeIGH
Weighing （ ）
Note: You cannot disable Weighing if you are in the mode currently.
LFt ON
will also be displayed briefly.
wWeIGH
is displayed.
t.wWt
is displayed.
mM.E.N.U
. Release the button and wait for the display to show
Available Settings
On, Off
OFF
is displayed.
mM.O.d.E
. Press the Yes button to enter the
Comments
To enable or disable Weighing
EN-19