H3C MPU-LSXM1SUPXD3 Manual

Manual version: APW100-20190430
1 Card identifier
The mark LSXM1SUPXD3 is printed at the upper right corner of the front panel to identify the card.
2 Specifications
Table 1 Card specifications
Item
Flash
BootROM
NVRAM
SDRAM (DDR3)
Card size (H × W × D)
Power consumption
Interfaces
Transmission rate
Transmission medium and max
transmission distance
Compatible device models
Software version
NOTE:
H3C recommends not using a USB extender cable to connect the USB port.
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
MPU—LSXM1SUPXD3
Specification
2 GB
8 MB
1 MB
8 GB
40 × 399 × 355 mm (1.57 × 15.71 × 13.98 in)
32W to 47W
•
1 console port
•
1 USB console port
•
4 network management ports: 2 RJ-45 ports and 2 SFP fiber ports
•
1 primary USB port
•
Console port: 9600 bps to 115200 bps (default: 9600 bps)
•
USB console port: ≤ 115200 bps (default: 9600 bps)
•
network management ports (RJ-45): 10/100/1000 Mbps, half/full
duplex
•
network management ports (SFP): 1000 Mbps
•
Console port: 15 m (49.21 ft) over asynchronous EIA/TIA-232
cables
•
USB console port: 10 m (32.81 ft) over USB-AB cables
•
network management ports (RJ-45): 100 m (328.08 ft) over
Category 5 or higher twisted pair cables
•
network management ports (SFP): GE SFP fiber module
specifications
S12508-XS
Release 7585P03 and later
i
BOM: 3123A1TK