Table of Contents
Advertisement
Tap to deactivate the WiFi
connection.
will appear on the display.
Tap to reactivate the WiFi
connection.
Tap to exit the menu level.
When the WiFi connection is active,
will light up on the start display.
Resetting the network configuration
Tap .
Swipe left or right until is shown in
the middle.
Tap .
Swipe right until is shown in the
middle.
Tap .
Tap OK.
All entered settings and values for
Miele@home are reset to the default
settings.
The WiFi connection has been
deactivated. will go out on the start
display.
Reset the network configuration if
you are disposing of or selling your
refrigeration appliance, or if you are
putting a used refrigeration appliance
into operation. All personal data is
removed from the refrigeration
appliance. This will also ensure that a
previous owner is no longer able to
access the refrigeration appliance.
Changing the volume of the alarms
and buzzers /
You can change the volume of the
alarms and buzzers (e.g. in the event of
a door alarm or a fault message).
Selecting further settings
Alternatively, you can switch the alarms
and buzzers off if you find them
annoying.
Tap .
Swipe left or right until is shown in
the middle.
Tap .
Select the volume you want by
swiping the segment bar to the left or
right.
Confirm the volume you want by
tapping on the segment bar.
When the alarms and buzzers are
switched off, will appear.
Adjusting the display brightness
You can adjust the display brightness to
the lighting conditions in the room.
Tap .
Swipe left or right until is shown in
the middle.
Tap .
Select the brightness you want by
swiping the segment bar to the left or
right.
Confirm the brightness you want by
tapping on the segment bar.
Switching off Demo mode
Demo mode allows the refrigeration
appliance to be presented in the
showroom without the cooling system
being switched on. This setting is not
needed for domestic use.
If Demo mode has been switched on
as a default setting, will show on the
start display.
Tap .
Tap .
49
Advertisement
Table of Contents
