Table of Contents
Advertisement
Selecting additional settings
Changing the volume of the alarms
and audible signals /
You can change the volume of the
alarms and audible signals (e.g., in the
event of a door alarm or a fault mes-
sage). Alternatively, you can switch the
alarms and audible signals off if you
find them annoying.
Tap .
Swipe left or right until is shown in
the middle.
Tap .
Swipe left or right until the volume
you want is shown in the middle.
Confirm the volume you want by tap-
ping on the segment bar.
When the alarms and audible signals
are switched off, will appear.
Adjusting the display brightness
You can adjust the display brightness to
the lighting conditions in the room.
Tap .
Swipe left or right until is shown in
the middle.
Tap .
Swipe left or right until the brightness
you want is shown in the middle.
Confirm the brightness you want by
tapping on the segment bar.
52
Switching off Demo mode
Demo mode allows the refrigeration
appliance to be presented in the show-
room without the cooling system being
switched on. Do not activate this setting
for domestic use.
If Demo mode has been switched on
as a default setting, will show on the
status display.
Tap .
Tap .
Swipe left or right until is shown in
the middle.
Tap .
After Demo mode has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings; see "Guide to the ap-
pliance").
Tap .
Swipe left or right until is shown in
the middle.
Tap .
will appear on the display.
Touch OK.
The refrigeration appliance shuts down
and must be switched on again.
Advertisement
Table of Contents
